Brake Products, Inc.   16751 Hilltop Park Place
  Chagrin Falls, Ohio 44023
  Phone: (440) 543-7962
  Fax:     (440) 543-7963
  Web:   www.brakeproducts.com
  Email: sales@brakeproducts.com
Supplier of Industrial Brake Parts Since 1985
Table of Contents
General Information
   • Size Selection
   • Preliminary Driveshaft Sizing Worksheet
Torque Specifications
   • Series 1310-1910
   • C-Series 2-15
   • Metric 120-435
   • Maximum Tubing RPM
Shaft Specifications
   • Series 1310-1550
   • Series 1610-1810
   • Series 1880-1910
   • C-Series 2-6
   • C-Series 7-10
   • C-Series 10.5-15
   • Metric 58-100
 		     • Metric 120-150HD
   • Metric 180-285
   • Metric 315-435HD
   • Metric 440-620
Flange Specifications
   • Series 1310-1910
   • Metric 58-150
   • Metric 180-390
   • Metric 435-550
   • Alternative Flange Connections
Maintenance of Universal Joint Driveshafts
Installation of Universal Joint Driveshafts
Bolt Torque Specifications
   • SAE & Metric
Rolling Mill Application Data for Selection and Design
General Application Data for Selection and Design
 
Download brochure in Adobe Acrobat® format (1.16MB)
Shaft Specifications
Ring Bearing Series C-Series 10.5-15
 

 
Torque Rating (lb. x ft.)
Shaft Series RA10.5C RA11C RA15C
Continuous Torque1 6,744 9,273 14,070
Short Duration Torque2 15,000 19,500 20,000
Minimum Elastic Limit 24,900 26,038 29,510
 
Shaft Specifications (Inches)
"A" Face to Centerline 1.34 1.58 1.50
"Z"
Min. Collapsed Length3		 28.38 T
23.50 SC		 30.32 T
25.00 SC		 30.60 T
24.75 SC
"C"
Slip Length4		 5.00 T
2.00 SC		 5.00 T
2.00 SC		 5.00 T
2.00 SC
U-Joint Swing Diameter 9.12 9.25 10.75
Max. Working Angle 25° 25° 25°
Max. Operating Speed5RPM 2,500 2,500 2,500
 
1. Reference only, based on 5,000 hours B10 life at 100 rpm, 3 degrees operating angle.
 
2. Represents capability of Universal Joint to withstand start and stop loading.
 
3. Type "T" refers to shaft requiring tubing, type "SC" refers to short coupled shafts. (Not Shown).
 
4. Standard lengths listed. Longer lengths available upon request.
 
5. Rating applies to Universal Joint, critical speed and joint angle must be considered.